Installing Or Removing The Sd Module - Lenovo ThinkServer TD350 70DG User Manual And Hardware Maintenance Manual

• To complete the removal procedure, go to "Completing the parts replacement" on page 164.
• If you are removing a RAID card, reconfigure RAID for your server. See "Configuring RAID" on page 58.

Installing or removing the SD module

This topic contains the following items:
• "Installing the SD module" on page 89
• "Removing the SD module" on page 90
Installing the SD module
Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 63.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Use any documentation that comes with the SD module and follow those instructions in addition to
the instructions in this topic.
To install the SD module, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server. If
the server is in tower form factor, lay the server on its side for easier operation.
3. Remove the server cover. See "Removing the server cover" on page 66.
4. Remove the cooling shroud. See "Removing the cooling shroud" on page 69.
5. Remove any parts and disconnect any cables that might impede your operation.
6. Locate the SD-module connector on the system board. See "System board components" on page 41.
7. Touch the static-protective package that contains the SD module to any unpainted surface on the
outside of the server. Then, take the SD module out of the package.
8. Insert the SD card into the SD card slot. The card might stop before it is completely installed into the SD
module. Ensure that you insert the card firmly until you hear a click.
.
Chapter 6 Replacing hardware
89