Removing And Reinstalling The Front Bezel - Lenovo ThinkServer TD350 70DG User Manual And Hardware Maintenance Manual

Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Depending on the model, your server might look slightly different from the illustration in this topic.
To reinstall the cooling shroud, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are
left inside your server.
2. Ensure that all cables inside the server have been properly routed so that they will not interfere with
installing the cooling shroud.
3. Note the orientation of the cooling shroud and then place it above the server. Align the tabs on both
sides of the cooling shroud with the corresponding gaps in both sides of the chassis. Then, lower the
cooling shroud into the chassis until it snaps into position.
Figure 32. Reinstalling the cooling shroud
4. Go to "Reinstalling the server cover and reconnecting cables" on page 164.

Removing and reinstalling the front bezel

Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 63.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Depending on the model, your server might look slightly different from the illustrations in this topic.
70
ThinkServer TD350 User Guide and Hardware Maintenance Manual