Service Status; Video Status Menu; Figure 4-39: Pvr 6000 Service Status Screen - Harmonic ProView PVR 6000 Series User Manual

4.3.3. Service Status

The Service Info is a section in the Status web-interface screen. It provides
information of service's status and parameters.
Figure 4-39 displays the Service Status Web management screen.
Figure 4-39:
The following parameters are displayed:
•
•
•
•
•
•

4.3.4. Video Status Menu

The Video Status Menu displays the status of Video and VBI parameters.
OSD parameter status will be available in future software versions.
The Video Status Menu provides an extended menu of status monitoring
options on Video and VBI data.
To access the Video Status Menu in the front panel control interface go to
Status Video.
The following screen displays the Video Status menu:
Video 1
1
VBI 1
2
Video 2
3
VBI 2
4
Figure 4-40 displays the corresponding Web management screen.
Page 4-154
PVR 6000 Service Status Screen
TV – This parameter indicates the active decoder as TV1 (or TV1/TV2 in
case of a dual decoder unit).
Service Name – This parameter displays the service's name.
Service Type – This parameter indicates the service type: TV, Radio, TLTX,
NVOD, MOSAIC, PAL, SECAM, MAC, FM, NTSC, and Data.
Service ID – This parameter displays the service identification symbol
[Hex].
Service Mode - Indicates if the service is encrypted (CAS) or free to air
(FTA).
Active in PAT – this parameter indicates whether the service is included in
the PAT table or not.
Video
User Manual
Operation and Management
1-3-4
(Rev. 4.1/ SW v1.60/ December 2006)