Harmonic ProView PVR 6000 Series User Manual page 258

10. In the Telnet prompt window, type 'telnet <unit IP Address> 1023' (use the
11. Type 'exit' and then Enter.
12. Type ' burn "vxw" ' and then Enter.
13. Type ' "burn "ird" ' and then Enter.
14. Power off the PVR 6000.
15. After a few seconds, power on the PVR 6000.
16. On the PVR 6000 front panel, go to Configuration
17. Verify the correct upgrading of the new SW version by going in the PVR
N
OTE
If power failure occurs during upgrade, repeat the upgrade from step 1
Page B-2
same IP Address as in step 9).
select FRONT END (IP)
6000 front panel to
Status Receiver General
parameter value
dd/mm/yy mj.mn
IP-Front End Software Upgrade Procedure
and checking the
(Rev. 4.1/ SW v1.60/ December 2006)
User Manual
Appendix B
Stream Source and
SW Version