Harmonic ProView PVR 6000 Series User Manual page 96

F
REQ
The PVR 6000 uses Freq Drift Compensation to automatically correct
inaccurate frequencies set by the operator.
When the operator sets the receiver frequency, the PVR 6000 checks whether it
is set to the optimum frequency. When a deviation is detected, the PVR 6000
calculates the offset from the original setting and enables correcting it.
Turning on the Freq Drift Compensation activates the automatic frequency
adjustment. When Drift compensation is turned off, the device uses the original
frequency setting that was inserted by the operator.
1
2
The available options are:
•
•
4.2.2.4. DVB-ATM Module
This section details the front panel menus that enable configuring the DVB-ATM
receiver in a PVR 6000 DVB-ATM front end device.
The following is the DVB-ATM Receiver Configuration menu as displayed on
the PVR 6000 front panel screen:
Mode
1
VPI Address
2
VCI Address
2
FEC
4
The available options are:
•
•
•
Page 4-26
D C
RIFT OMPENSATION
Freq Drift Compensation
OFF
ON
OFF – Drift Compensation is off; the receiver remains with the configured
frequency.
ON - Drift Compensation is on; the receiver adjusts its optimal frequency.
General
Mode – this parameter allows the user to set the
operational mode of the ATM receiver.
VPI Address –this parameter allows the user to set
the path address for the ATM receiver.
VCI Address – this parameter allows the user to set
the channel address for the ATM receiver.
User Manual
Operation and Management
1-2-1
(Rev. 4.1/ SW v1.60/ December 2006)
DS3
01
0020
ENABLE