Figure 2-2: Rack Slide Measurement Specifications - Harmonic ProView PVR 6000 Series User Manual

Figure 2-5 illustrates the exact measurements of special rack-slides.

Figure 2-2: Rack Slide Measurement Specifications

Fasten the pair of rack slides to the rack's side rails in the device's designated
location with four M6 screws (two on each side of the rack) before continuing.
After tightly fastening the supporting rack-slides to the rack, perform the
following steps to install the device within the rack:
1. Lay the device on the rack-slides in its designated location within the rack.
Figure 2-3 is a see-through illustration, demonstrating the placing of the
device on the rack-slides.
Page 2-4
User Manual
Installation
(Rev. 4.1/ SW v1.60/ December 2006)