Harmonic ProView PVR 6000 Series User Manual page 128

The following screen displays the Service configuration menu:
TV1 Select
1
TV2 Select
2
Stand-Alone Select
3
Preferred Language
4
PID Select
5
Mapping Port to Service
6
General Configuration+
7
The Service Configuration Menu parameters are as follows:
•
•
•
•
•
•
Page 4-58
Service
TV1 and TV2 Select (if applicable)
Enables assign a service from the incoming TS to a decoder. In the case of a
dual decoder, a user can assign two services from the incoming TS, one for
each decoder (see Section 4.2.5.1).
Stand-Alone
This feature will be supported in the future software releases.
Preferred Language
This group contains parameters that define the preferred language (see
Section 4.2.5.3).
PID Select
This group contains parameters that define the PID components in the
elementary stream (see Section 4.2.5.4).
Mapping Port to Service
This group contains parameters that define the port mapping and service
components for each elementary stream (see Section 4.2.5.5).
General Configuration
This group contains parameters that define the response of the PVR 6000 to
various operational modes (see Section 4.2.5.6).
User Manual
Operation and Management
1-2-3
(Rev. 4.1/ SW v1.60/ December 2006)