Filtering - Harmonic ProView PVR 6000 Series User Manual

4.2.4. Filtering

Filtering is a licensing required feature that allow the user to define a method
for PID Filtering on PVR 6000 ASI and IP output ports.
The following summarizes the Filtering procedures, using both Front Panel and
Web-Based Management interfaces:
F
ILTERING THROUGH THE
In order to use filtering mode thru the front panel perform the following steps:
•
•
General
1
Service
2
PID
3
•
•
•
F
ILTERING THROUGH THE
In order to use filtering mode thru the front panel perform the following steps:
•
Page 4-46
Configure ASI or/and IP outputs to filtering mode (see section 4.2.3.2:
Configuration Stream
Configuration Stream
Access the general screen by navigating to:
Root Configuration Stream Filtering
Filtering
Set the following parameters at the General sub menu: strategy, mode, Bit-
rate mode and bit-rate. (see section 4.2.4.1)
Configuration Stream
In case that the service filtering strategy is chosen, select the services (see
section 4.2.4.2)
Configuration Stream
In case that the PID filtering strategy is chosen, select the PIDs (see section
4.2.4.3)
Configuration Stream
configure ASI or/and IP outputs to filtering mode:
Stream General Output
Stream General Output
Operation and Management
F P
RONT ANEL
Output ASI Output Source
Output IP Output Source
Filtering General
Filtering Service
Filtering PID
W -B
EB ASED
ASI Output Source
IP Output Source
(Rev. 4.1/ SW v1.60/ December 2006)
User Manual
After Filtering
After Filtering
1-2-2-4
M
ANAGEMENT
After Filtering
After Filtering