To access the Unit Configuration Menu in the front panel control interface go to
Configuration Unit.
The following screen displays the Unit menu:
General
1
Serial Control Port
2
Ethernet Management Port
3
Licensing
4
Dry Contact
5
The Unit Configuration Menu parameters are as follows:
General
Allows operator to set the LCD contrast value and perform soft reset (see
Section 4.2.10.1)
S
ERIAL
Allows operator to configure the control port parameters (see Section 4.2.10.2)
E
THERNET
Allows operator to configure the Ethernet management port (see Section
4.2.10.4)
L
ICENSING
Allows operator to activate features that require software license (see Section
4.2.10.5)
D
RY
Allows operator to configure GPI-1 and GPI-2 parameters (see Section 0)
Page 4-128
Unit
C
P
ONTROL
ORT
M
ANAGEMENT
C
ONTACT
Operation and Management
P
ORT
(Rev. 4.1/ SW v1.60/ December 2006)
User Manual
1-2-8