Chapter 5: Operation and Management
5.4.3. Service Status
The Service Info is a section in the Status web-interface screen. It provides information of
service's status and parameters.
Figure 5-10 displays the Service Status Web management screen.
The following parameters are displayed:
TV – This parameter indicates the active decoder as TV1 (or TV1/TV2 in case of a dual
•
decoder unit).
Service Name – This parameter displays the service's name.
•
Service Type – This parameter indicates the service type: TV, Radio, TLTX, NVOD,
•
MOSAIC, PAL, SECAM, MAC, FM, NTSC, and Data.
Service ID – This parameter displays the service identification symbol [Hex].
•
Service Mode - Indicates if the service is encrypted (CAS) or free to air (FTA).
•
Active in PAT – this parameter indicates whether the service is included in the PAT table
•
or not.
5.4.4. Video Status Menu
The Video status menu displays the status of Video and VBI parameters. It provides an
extended menu of status monitoring options on Video and VBI data. To access the Video
status menu in the front panel control interface go to Status Video.
The following screen displays the Video Status menu:
1 Video 1
1 Video 1
1 Video 1
1 Video 1
2 VBI 1
2 VBI 1
2 VBI 1
2 VBI 1
3 3 3 3 OSD 1
OSD 1
OSD 1
OSD 1
Figure 5-11 displays the corresponding Web management screen.
The Video status menu parameters are as follows:
Video 1 / Video 2 (if applicable) – This group displays information about the video for
•
Decoder #1 / Decoder #2 (see Section 9.2).
VBI 1 / VBI 2 (if applicable) - This group displays information about the VBI for Decoder
•
#1 / Decoder #2 (See Section 9.3).
© Harmonic Inc. Manual p/n 101543/Ver 1.0
Figure 5-10:
ProView 2900 Service Status Screen
Video
Video
Video
Video
Figure 5-11:
ProView 2900 Video Status Screen
5-22
ProView 2900 Status Menu
1 1 1 1 - - - - 3 3 3 3 - - - - 4 4 4 4
ProView 2900 Series/SW Version 1.94