Figure 4-37: Pvr 6000 Dvb Ip Status Screen - Harmonic ProView PVR 6000 Series User Manual

PVR 6000 Series
Professional Integrated Receiver Decoders
•
•
•
•
•
•
N
OTE
All displayed frequencies are in L-Band.
4.3.1.3. IP Receiver Status
The IP Receiver Status menu enables monitoring
parameters. It displays both static information (such as MPEGoIP port MAC
Address) and live data (e.g. type of data encapsulation received, current bit
rate, whether or not IP parameters are valid, etc.).
To access the IP Receiver Status menu in the front panel interface go to
Status Receiver
The IP Receiver Status menu as displayed on the PVR 6000 front panel
screen:
MPEGoIP Input 1
1
MPEGoIP Input 2
2
General
3
Figure 4-37displays the corresponding Web management screen.
Figure 4-37:
Frequency Tune – This parameter points out the optimal frequency
checked by the PVR 6000 for obtaining the highest quality of the received
signal.
Frequency Offset – displays the deviation between the frequency inserted
by the operator and the frequency that was indicated by the Frequency
Tune.
Modulation – displays the configured modulation method
FEC Rate – reports the selected FEC rate
Roll Off – the configured Roll-Off factor value
Spectral Inversion – When the Spectral Inversion mode is set to automatic
(see Section 4.2.2), the value displayed is the one selected by the device.
Otherwise, this parameter displays the Spectral Inversion method that was
selected manually.
Receiver
PVR 6000 DVB IP Status Screen
the main IP receiver
1-3-1
Page 4-149