Utility mode
–
Each time [+] or [-] is touched, the value is increased
or decreased by one increment.
–
If the folding position is too far to the right of the
center of the paper, touch [-] to reduce the
adjustment (between -5.0 and +5.0).
8
Touch [OK].
–
To cancel the setting and select the default, press the [Reset] key.
The center folding position is adjusted.
If the folding position was at the center of the paper in step 7, this completes the procedure.
9
Use the "Half-Fold" setting to print another sample copy.
10
Check the print result.
–
Check that the folding position is adjusted to the center of the paper.
–
If more adjustment is necessary, repeat steps 6 through 9.
Note
Set the value by mm. Refer to the conversion rate below.
1 inch = 25.4 mm
11.6.2
Center Staple Position Adjustment
The stapling position when printing with the "Center Staple & Fold" setting can be adjusted for each paper
size.
Note
[Center Staple Position Adjustment] does not appear if optional finisher and Saddle stitcher are not
installed.
If the angle of the staple must be adjusted, contact your service representative.
!
Detail
For details on the "Center Staple & Fold" setting, refer to
Staple & Fold" setting)" on page
For the procedure on adjusting the center folding position, refer to
page
11-39.
0
Adjust the center folding position before adjusting the center stapling position.
501/421/361
"Binding copies at the center ("Center
2-65.
"Half-Fold Position" on
11
11-40