Punch Horizontal Position Adjustment - Konica Minolta bizhub C451 User Manual

Utility mode
– If the punch positions are too far blow the center of the paper, touch
[-] under "Adjust Value" to increase the adjustment (between -0.1
mm and -5.0 mm).
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The vertical position of the punched holes is adjusted.
If no adjustment of the vertical position of the punched holes was
necessary in step 7, this completes the procedure.
9
Use a Punch setting to print another sample copy.
10
Check the print result.
– Check that the vertical position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.

Punch Horizontal Position Adjustment

The horizontal position of punched holes when printing with a Punch setting
can be adjusted for each paper size.
Note
[Punch Horizontal Position Adjustment] appears only if optional punch kit
is installed on the finisher.
For details on the Punch settings, refer to "Punching holes in copies
(Punch settings)" on page 2-93.
The adjustment range differs depending on the finisher that is installed.
C451
11
11-84