Ethernet - Christie Roadster S+ User Manual

TROUBLESHOOTING
5.3

Ethernet

5-4
Roadster/Mirage S+ User's Manual
1. Make sure the Ethernet settings are valid for your site—all network devices should
have the same subnet mask and unique IP addresses.
2. Make sure the projector is connected to a network before you attempt to change its
IP address, and always cycle power (off-on) to implement the new IP address.
3. Make sure to save any address change, and re-boot to implement.
4. If you still have trouble establishing communications with a projector added to an
existing Ethernet network, the projector's IP address is likely in conflict with
another address already in use. Contact your network administrator.