Christie Roadster S+ User Manual page 38

INSTALLATION & SETUP
2-32
Roadster/Mirage S+ User's Manual
TO CHANGE FROM INFRARED TO WIRED:
1. Remove battery compartment cover from back of keypad.
2. Remove batteries.
3. Wait 1-2 minutes. Meanwhile, notch the battery cover to create an exit hole
for the cable. Make sure hole is smooth and will accommodate the cable
without pinching.
4. Plug the keypad cable (supplied) into the empty battery compartment—make
sure to orient the connector correctly (red wire nearest to the edge).
5. Set keypad protocol to "wired" jumper setting (refer back to Figure 2.44).
Make sure to set jumper #4 between pins 2 and 3 as shown in the last
example (shaded).
6. Replace battery compartment cover, keeping the strain relief tie just inside
the battery compartment at the exit notch.
7. Plug into the port labeled
TO CHANGE FROM WIRED TO INFRARED:
1. Unplug the keypad from the projector.
2. Open the keypad back and unplug the keypad cable.
3. Wait 1-2 minutes.
4. Install batteries (see Section 4)
5. Set jumpers according to the desired IR protocol (refer back to Figure 2.44).
Make sure to set jumper #4 between pins 1 and 2 as shown for all remote IR
protocols.
6. Replace battery compartment cover.
on the projector's input panel.
REMOTE