Table of Contents
Advertisement
Keypad Commands
Channel
3)
Hold arrow keys down for continuous adjustment/movement in one direction. In
serial networks, pause briefly between adjustments to ensure that more distant
projectors can "keep up" with the commands.
If you press a key while the projector is still responding to the previous action,
4)
such as during power-up, the second key press may not take effect.
'
Specific keypad commands are explained below:
Power ON/OFF
Press and hold
Or press and release
guarantee the correct toggle (useful if you are unsure of the present state).
NOTES: 1) After powering down, the lamp cooling fan remains on for approximately
5 minutes to cool the lamp. 2) It is a good idea to avoid turning a projector back on
until it has been off for several minutes. Hot re-strikes of the lamp may reduce lamp
life.
Test
T est
Press
to scroll through the projector's internal test patterns. When a test pattern
T est
is up, use
Auto
Auto
Setup
Auto
Press
to initiate an automated process in which the projector optimizes critical
Setup
display parameters such as size, position, pixel tracking, etc., for the current unlocked
channel. These parameters are listed in Table 3.1. An Auto Setup can save time in
perfecting a display, and you can further modify the settings as desired.
OPTIMIZES:
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
Channel
Press
to select a specific source setup (channel) defined and stored in projector
Channel
memory. Once you enter a 2-digit channel number (or, if there is a list displayed,
highlight it and press
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust an image from a new source.
NOTE: Channel (
not the Display Channel List option is enabled in the Menu Preferences menu. You
can choose to use a scrollable list of channels when you press
to enter the desired channel number "blind", i.e., without on-screen feedback. See
Menu Preferences later in this section.
briefly to toggle the projector on or off with a single keystroke.
followed immediately by
to scroll through the patterns without going back to the input.
Table 3.1. Auto Setup
What an "Auto Setup" Does
), the display will automatically change and update
) key behavior during a presentation depends on whether or
Channel
(on) or
SETS TO DEFAULT:
Contrast
Brightness
Auto Input Level (off)
Detail
(if video source)
Filter
Luma Delay
, or you may prefer
Channel
Roadster/Mirage S+ User's Manual
OPERATION
(off) to
3-7
Advertisement
Table of Contents
