Connecting The Ethernet Cable To The Projector - Christie Eclipse Installation And Setup Manual

12. To lock the fiber in place, rotate the locking collar clockwise until you see the locking pin start
to turn and no longer moves forward and then rotate the knurled ring clockwise.
13. Re-attach the cover to the fiber strain relief and tighten the five screws removed in step 6 to
secure it.

Connecting the Ethernet cable to the projector

Connect the projector to the laser illumination source with an Ethernet cable.
1. Connect one end of an Ethernet cable to the Laser Rack network port on the Video Input panel
of the projector.
2. Connect the other end of the Ethernet cable to the network port on the lower-left rear side of
the laser illumination source.
Two Ethernet port styles are available on the laser illumination source and the style shown
below may not match the style on your laser illumination source.
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
43