Christie Roadster S+ User Manual page 17

STEP 5 ' Align the centerlines of the grid
Turn the (2) rear stacking mount
wheels to move the top projector
as necessary for well-aligned
centerlines. Use a screwdriver in
the holes around the rim of each
adjusting wheel for better leverage
and control.
HOW TO MOVE THE IMAGE:
Turned independently, each
stacking mount acts as a pivot
point for the opposite edge of the
display (Figure 2.15). For
example, turn the right mount to
tilt the left portion of the image up
or down, and turn the left mount to
tilt the right portion of the image
up or down. Turn together to raise
or lower the top image like an
offset adjustment, or turn the front stacker.
IF THE CENTER LINES FORM AN "X":
are slightly tilted in relation to one another. Turn one mount to raise one side, and/or
turn the other mount to lower other side. See Figure 2.15.
IF THE CENTER LINES ARE PARALLEL BUT MISALIGNED:
• If centerlines are out by the same amount from top
and bottom – use offsets (on top projector) to bring
the centerlines into alignment.
• If centerlines are parallel but
others are not, turn the front
stacking mount wheel to bring
the centerlines into alignment.
STEP 6 ' Align the edges of the grid
With centerlines aligned, adjust zoom (top projector) to align the edges of its image
with the other image. Then adjust focus. When aligned, all lines from the combined
red/green grids will be yellow.
INSTALLATION & SETUP
Figure 2.15. Adjustment Directions (Tilt)
This indicates that the projectors (and images)
Roadster/Mirage S+ User's Manual
2-11