Table of Contents
Advertisement
Ventilation
'
Before unplugging the power cord, make sure the internal lamp cooling fans have
shut off. The fans automatically shut off when the projector has adequately cooled
down.
Slots and openings in the projector provide ventilation. To ensure reliable operation
of the projector and to prevent overheating, these openings must never be blocked or
covered. The projector should never be placed near or over a radiator or heat register.
The projector should not be placed in an enclosure unless proper ventilation is
provided. For best results, ensure that the projector bottom is above any "lip" that
may be present on a cart—extend projector feet as necessary.
Do not push objects of any kind into the projector through the ventilation openings.
They may touch dangerous voltages or short-out components resulting in a fire or
shock hazard. Do not spill liquids of any kind into the projector. Should an accidental
spill occur, immediately unplug the projector and have it serviced by a qualified
service technician.
Servicing
'
If any of the following conditions exist, immediately unplug the projector from the
power outlet and refer service to qualified service personnel.
•
The power cord has been damaged.
•
The internal cooling fans do not come on within 2 minutes after the projector is first
turned on.
•
Liquid has been spilled into the projector.
•
The projector has been exposed to excessive moisture.
•
The projector does not operate normally.
•
The projector has been dropped or the case has been damaged.
•
Projector performance has deteriorated.
Operate the projector at the specified voltage only. Do not overload power
outlets and extension cords as this can result in fire or shock hazards.
The projector is equipped with a three-wire plug having a third (grounding)
pin. This is a safety feature. If you are unable to insert the plug into the
outlet, contact an electrician to have the outlet replaced. Do not defeat the
safety purpose of the grounding-type plug.
Do not attempt to service the projector yourself. All
servicing must be performed by CHRISTIE accredited
Use replacement parts that are manufacturer-approved
only. Use of any other part other than the ones specified
by the manufacturer can result in fire, electric shock or
risk of personal injury and irreparable equipment
WARNING
service technicians.
damage.
Roadster/Mirage S+ User's Manual
MAINTENANCE
4-3
Advertisement
Table of Contents
