Christie Roadster S+ User Manual page 88

OPERATION
System Configuration
OPTIONAL INPUT MODULES
3-50
Roadster/Mirage S+ User's Manual
LiteLOC™ Calibration
NOTES: 1) LiteLOC™ Calibration takes up to two minutes. 2) For best results,
allow the projector to warm up for 15 minutes prior to calibration.
LiteLOC™ Calibration defines the range of power needed to maintain lamp
brightness. Select Calibrate LiteLOC for calibration using your projector's unique
specifications (recommended) rather than standard specifications. The projector will
revert to the default back-up in the event of a power failure.
Intelligent Lens System (ILS
This option allows you to choose between three types of lens calibrations. Reference
calibration determines a reference point that is used as a defined starting position for
relative motion of the lens. All positioning is measured from this reference point. A
reference calibration is lost when power is removed from the projector and will
occur on every power up as long as ILS is enabled. A motion calibration
determines the characteristics of each motor and values are saved in the projector's
memory. If ILS is enabled and a motion calibration has previously been done, the
projector will automatically recall these settings from memory when it's being
powered up and a motion calibration will not take place. A full calibration performs
both a reference and motion calibration.
Aspect Ratio Overlay
Selecting this option with a checkmark will overlay a number of common aspect ratio
boxes on top of the source image. This is very helpful during the setup of the
projector and can be turned off after desired specifications have been achieved.
' The two "Option
Card" entries In the
Configuration
menu identify
which optional
input modules
(a.k.a. cards) are
present at
INPUT 5
(Option 1) and
(Option 2).
INPUT 6
If either of these option slots is empty, the corresponding read-only menu entry does
nothing. If there is a module installed, the corresponding menu entry may activate a
submenu of further options pertaining to that module.
For example, on Roadster models the Dual SD/HD-SDI module is factory-installed at
(Option 1). The Option 1 Card submenu provides controls for configuring
INPUT 5
the various connections on this multi-input, multi-output module. As desired for your
application, you can define 1) which physical input loops through to which output,
and 2) which functional input (main or PIP signal) loops through to which output.

) Calibration