Table of Contents
Advertisement
3. OPEN THE LAMP DOOR
WARNING
Protective gear required. Wear a
face shield.
Using a #2 Phillips screwdriver,
loosen the ¼-turn lock screws (2)
securing the lamp door, which is
located at the rear of the projector
below the input panel. See Figure
4.2.
4. REMOVE LAMP
RETAINING BAR
Remove the two (2) screws that secure the retaining bar along the bottom edge of
the lamp module using a #2 Phillips screwdriver. See Figure 4.3. Swing the bar
aside—it is hinged on the left.
Figure 4.3. Remove Retaining Bar
5. REMOVE THE LAMP MODULE
Firmly grasp the handle and pull the lamp module straight out of the projector.
See Figure 4.4. Discard the lamp using safe disposal/recycling practices.
Figure 4.4. Remove Lamp Module
Figure 4.2. Open Lamp Door
Roadster/Mirage S+ User's Manual
MAINTENANCE
4-7
Advertisement
Table of Contents
