Christie Roadster S+ User Manual page 114

MAINTENANCE
Lamp and Filter
Replacement
Power Cord
and Attachments
4-2
Roadster/Mirage S+ User's Manual
A projector and cart combination should be used with care. Sudden stops, excessive
force, and uneven surfaces may cause the projector and cart combination to overturn.
Do not operate the Bubble lamp for more than the lamp's warranty limit; risk
'
LAMP:
of the lamp shattering increases as a result of changes in the quartz glass that occur
with use. Operation beyond the lamp's warranty limit also significantly reduces
brightness output.
Wait approximately 5 minutes after powering down the
projector to allow internal cooling fans to stop and for
the lamp to cool sufficiently before removing.
Never attempt to remove the lamp housing directly after use.
The lamp is under great pressure when hot and may explode,
causing personal injury and/or property damage. Allow cooling
The Bubble lamp operates at a very high temperature and pressure. Failure to allow
the lamp to sufficiently cool prior to handling could result in an explosion causing
personal injury and/or property damage. After turning the projector off it is important
that you wait at least five minutes before unplugging it. This provides enough time
for the internal lamp cooling fans to cool the lamp and to automatically shut off. Cool
completely before handling.
Use only lamps supplied by Christie. Use lamps of the
correct wattage for your projector model when
Replace the front filter when you replace the lamp or sooner. If this filter is
FILTER:
not replaced, airflow may become restricted and cause the projector to overheat.
See 4.4, Replacing the Lamp and Filter for the complete replacement procedure.
'
The North American rated line cord is provided with each projector.
Ensure that you are using a line cord that meets the appropriate rating
standards (CCC for use in China, PSE for use in Japan).
Only use attachments or accessories recommended by Christie, such as the specific
power cord supplied. Use of other attachments or accessories with this projector may
result in the risk of fire, shock or personal injury.
Use only the AC power cord supplied. Do not attempt operation
if the AC supply and cord are not within the specified voltage
Do not allow anything to rest on the power cord. Locate the projector where
persons walking on it or objects rolling over it cannot abuse the cord.
WARNING
completely.
WARNING
replacing.
WARNING
Use only filters supplied by Christie.
WARNING
and power range. See Section 6.