Christie Roadster S+ User Manual page 8

INSTALLATION & SETUP
STEP 4 '
STEP 5 '
STEP 6 '
2-2
Roadster/Mirage S+ User's Manual
◊ The Roadster S +
12K requires 200-240 VAC, 50-60 Hz, 12 amps @ 200 VAC.
◊ The Roadster S +
16K and the Mirage S
amps @ 200 VAC.
◊ The Roadster S +
20K requires 200-240 VAC, 50-60 Hz, 24 amps @ 200 VAC.
Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range. See Section 6.
Turn On the Projector and Lamp
1. On the projector, turn the power
breaker/switch on. The LCD Status
Display Window displays the
initializing window for 15 seconds,
then indicates
POWER OFF
right).
2. Using the keypad, do one of the
following:
• Press and hold
toggle the lamp on.
• Press and release
immediately by
• Press to toggle from the
off state.
The LCD Status Display Window
will display Powering Up and
then, Power On (Figure 2.1) while
the 2 Digit Status/Error Code
Window will display ON.
Select a Source
Using either keypad, press
the image for the source you connected in Step 2. The display will resize as needed,
producing an image as large as possible for the type of source present.
Optimize the Display
Press Auto on the built-in keypad (or
Setup
automated process in which the projector optimizes critical display parameters such as
size, position, pixel tracking, etc., for the current source. Auto Setup can save time in
perfecting a display, and you can modify the adjustments later as desired. See Section 3.
+
14K require 200-240 VAC, 50-60 Hz, 16
WARNING
(see
briefly to
followed
.
Figure 2.1. Turning on the projector
, ,
,
Input 1 Input 2 Input 3 Input 4
on the remote keypad) to initiate an
, , or
to select and display
Input 5 Input 6