Table of Contents
Advertisement
INSTALLATION & SETUP
2.8
Operating
Orientation
2.9
Leveling
2-28
Roadster/Mirage S+ User's Manual
Do not attempt operation if the AC supply and cord are
not within the specified voltage and power range.
Caution for Shutdowns: Once the projector is turned off (
cooling fans will continue to run for approximately five minutes to ensure that the
projector and lamp have sufficiently cooled, at which point the fans will
automatically shut off. To avoid thermal stress that can lead to premature lamp
failure, never unplug the line cord while the lamp cooling fans are running, and
never unplug to power down.
The projector is set up at the
factory for use in a front
screen, floor mount
orientation. If your initial
installation is ceiling mount
or rear screen, displayed
images may be upside down
and/or reversed. To correct,
you must change the image
orientation from within the
Configuration Menu (you
may prefer to do this before
physically installing the
projector in its final
position/orientation).
In the Configuration Menu highlight and select the "Image Orientation" pull-down
list. See Figure 2.38. Select from Rear, Inverted Rear, Front or Inverted Front
according to your intended installation. See Section 3, Operation for further
information.
For most installations, the lens surface of the projector is parallel to the screen—this
prevents major keystoning of the image (i.e., an image with non-parallel sides). In
addition, the projector must be kept level from side-to-side in order for the lamp to
function safely. To make small corrections to the projector's level, rotate each leg as
necessary to raise or lower. See Figure 2.39. For angled installations, see "Special
Mounting" under 2.3, Projector Position and Mounting earlier in this section.
Figure 2.39. Adjusting the Feet Height
WARNING
Figure 2.38. Image Orientation
), the lamp
Advertisement
Table of Contents
