Christie Roadster S+ User Manual page 60

OPERATION
Before You Begin
Size and Position Menu
3-22
Roadster/Mirage S+ User's Manual
Use Auto Setup (
'
For a good and efficient first step in perfecting the image, press
an automated process in which the projector quickly optimizes critical display
parameters for unlocked channels such as size, position, pixel tracking, etc., based on
the type of incoming source data detected. An Auto Setup can save considerable setup
time, and you can still modify the adjustments as desired using menu options
described below.
' In the Size and Position menu, you
can increase or decrease the size of
your main image, change its
proportion (aspect ratio), move the
image to a specific area of the
screen, and refine other related
parameters. Use Size and Position
controls to match the image
precisely to the screen used at the
site.
Refer to "Using Slidebars and
Other Controls" (earlier in this section) if you need help using any of the options and
controls. Changes made in the Size and Position menu are applied immediately and
are saved when you exit the menu (press
Resize Presets
Select a Resize Presets option to
quickly display an image in its
native resolution or to
automatically resize an image to
closely fill the projector's native
resolution of 1400 x 1050, or to
optimize the width or height of
your display. Size, Position and
Blanking parameters will
automatically adjust accordingly.
Or, if Blanking is set first, which defines an Active Input Area, Resize Preset scaling
will occur in this region of interest only. Resizing options are explained in detail
below.
WHAT IS THE RESIZING DEFAULT?
image will utilize as much of the projector's display area (1400 x 1050) as possible
for the type of incoming source data. See Select "Default" below.
WHEN "CUSTOM" APPEARS:
in the Size and Position menu when any of the values for Size, Vertical Stretch, H-
Position, V-Position or Blanking do not correspond to those for a preset. It is not a
choice in the Resize Presets pull-down list.
• Select
"DEFAULT"
and displayed as large as possible depending on the type of source, as described
below:
)
Aut o
Set up
Exit
By default when displaying a new source, your
The "Custom" re-size descriptor automatically appears
for most sources (factory default). The image will be centered
. This initiates
Aut o
Set up
or ).
Menu