Christie Roadster S+ User Manual page 14

INSTALLATION & SETUP
STEP 3 '
STEP 4 '
2-8
Roadster/Mirage S+ User's Manual
Extend the (3) stacking legs
Extend the stacking legs by turning
them so that at least 1 inch of thread is
visible on each. This clearance
accommodates the up-or-down
movement for aligning the images from
stacked projectors. Extend all 3 legs
equally (Figure 2.11).
• If upright – extend legs on top
projector (shown).
• If inverted – extend legs on bottom
projector.
IMPORTANT
Extend the stacking legs
equally by at least 1 inch.
Loosen the rear stacking leg nuts
On the rear stacking legs, loosen the nuts so the legs have some lateral movement for
easier alignment with the stacking mounts on the other projector.
• If upright – release on top projector.
• If inverted – release on bottom projector.
Figure 2.11. Extend 3 Stacking Legs
Figure 2.12. Loosen 2 Nuts
(UPRIGHT STACK SHOWN)