System Integration - Christie Roadster S+ User Manual

Configuring the GPIO

System Integration

The GPIO (General Purpose Input/Output) connector located on the input panel
provides a flexible method of interfacing a wide range of external I/O devices to the
projector. There are 7 GIO pins available on the 9pin D-Sub GPIO connector, which
are configurable via RS232 commands. The other two pins are reserved for ground
and power – see table below for pin identification.
1
2
3
4
5
6
7
8
9
The serial cable required for connecting the external device to the projector's GPIO
connector, whether it's a standard serial cable or a custom one, must be compatible
with the external device.
' The GPIO connector can be configured to automate any number of events using the
serial command code GIO. Each pin is defined as either an input or output
depending on the desired outcome. In general, configure the pin as an input if you
want the projector to respond to something the device does and as an output if you
want the external device to respond to an action taken by the projector. For example,
configure the pin as an output if you want the lighting in a room to automatically dim
when the projector is turned on.
GPIO
1 2 3 4 5
6 7 8 9
Pin #
+ 12V (200mA)
GPIO 1
GPIO 2
GPIO 3
Ground
GPIO 4
GPIO 5
GPIO 6
GPIO 7
Roadster/Mirage S+ User's Manual
A p p e n d i x E
GPIO Pins
Signal
E-1