Table of Contents
Advertisement
INSTALLATION & SETUP
the source provides separate horizontal and vertical sync outputs, connect horizontal
sync to the
input labeled
and connect vertical sync to
input
SYNC
HOR/COMP,
SYNC
labeled
See Figure 2.25, below.
VERT.
Figure 2.25. Connecting RGB Input
NOTES: 1) If for some reason the projector fails to recognize a signal as an RGB signal,
specify this Color Space option within the Image Settings menu. See 3.6, Adjusting the
Image. 2) To connect YPbPr signals–such as from DVDs or analog HDTV sources–to
, use the red, green and blue BNCs as described in YPbPr Signals (below)
INPUT 1
YPbPr
Connect a YPbPr signal (a.k.a. component video) to
or
as shown in.
'
INPUT 1
INPUT 2
(COMPONENT VIDEO)
Figure 2.26.
NOTES: 1) If, for some reason, the projector fails to recognize a YPbPr signal,
specify this Color Space option within the Image Settings menu. See 3.6, Adjusting
the Image. 2) Do not connect digital component signals (known as YCbCr) to
INPUT
. Use the appropriate digital interface option installed at
.
1 or 2
INPUT 5 or 6
Figure 2.26. Connecting YPbPr
2-19
Roadster/Mirage S+ User's Manual
Advertisement
Table of Contents
