Input Panel - Christie Roadster S+ User Manual

Input Panel

The input panel wires the projector to inputs (sources) and controllers such as PCs.
COMPOSITE/S-VIDEO INPUT -
signal from devices such as VCRs.
Accepts RGB and sync signals from devices such as computers,
RGB INPUT -
as well as composite video, S-Video or YPbPr component signals.
RS232 SERIAL INTERFACE (WITH LOOP THROUGH) -
projectors to be remotely controlled by a computer or controller,
RS422 INTERFACE -
an RS422 compatible computer or controller (such as the Two-Way Controller
accessory).
AC Power Input and Monitoring
AC LINE CORD INPUT -
line cord provided with the projector. See Section 5. Before unplugging, wait until
the main blower turns off or the LCD status reads Power Off.
Model
Roadster S+12K
Roadster S+16K
Mirage S+14K
Roadster S+20K
Do not attempt operation if the AC supply is not within the
specified voltage and power range. Use the specified line cord.
Displays incoming voltage level reaching the projector.
VOLTMETER -
SWITCH/BREAKER -
a power switch for the ballast 2) It protects against excessive AC conditions
(15A or more for Roadster S
+
S 14K, and 25A or more for Roadster S
excessive AC is detected, the breaker will "trip" to OFF in order to prevent
damage. Try moving the breaker ON again - if the breaker continues to trip
OFF, this indicates a major fault and the AC problem must be resolved.
Possible causes might include shorts, damage to lamp cables, or excessive AC.
NOTE: This switch powers only the ballast—it does not power up the projector or
start the lamp. You must press
Two Status Displays:
2-DIGIT STATUS/ERROR CODE WINDOW -
display is adjacent to the built-in keypad. During normal operation, the
"Power" light is steady yellow and indicates "on". When the status of the
projector changes, the LED displays a 2-digit code number representing the
projector's new status. In addition to the numeric readout, there are two
decimal points in the display: the right decimal point flashes when the projector
receives a command, and the left point flashes when the projector sends a
command.
Accepts a composite video, DVI and S-Video
Allows one or more projectors to be remotely controlled by
Use the AC supply specified, and always use the
AC Power Specifications
200-240 VAC, 50-60 Hz, max. 15 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 20 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 20 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 25 amps @ 200VAC
WARNING
The breaker on the rear panel serves two purposes: 1) It is
+
12K 20A or more for Roadster S
+
20K). If the projector is faulty or
on the keypad.
This LED (light emitting diode)
Roadster/Mirage S+ User's Manual
OPERATION
Allows one or more
+
16K/Mirage
3-3