Set up the ethernet
Ethernet is setup to obtain an IP address automatically if a DHCP server is on the network. To
modify IP settings, or manually enter an address.
1. On the touch panel controller, tap Menu > Configuration > Ethernet Settings > Modify
IP Settings.
2. Set the network information for the projector:
•
To obtain information automatically from the network, tap Automatic.
•
To manually enter the network information, tap Manual and enter the IP Address,
Subnet Mask and Gateway (optional).
3. Click Ok.
D4K2560 Setup Guide
020-101171-04 Rev. 1 (01-2015)
Connect Devices
26