Table of Contents
Advertisement
About Alarms
NOTE: Simple Network Management Protocol (SNMP) is not compatible with the
This section provides information on:
•
•
•
•
Overview
The VN-Matrix system is configured to generate alarms for error conditions. A list of these
error conditions and their meanings are presented on the following pages.
Alarms can be monitored using the web interface at the following locations.
•
•
•
•
Alarm conditions, when triggered, remain active for the entire duration of the error condition
and for an additional five seconds after the error has cleared.
VNM Recorder and not covered in this user guide. For information on using SNMP,
see the VN-Matrix 200 Series User Guide, VN-Matrix 225 Series User Guide,
VN-Matrix 300 User Guide, and the VN-Matrix 325 User Guide.
Overview
Alarms Page
Alarm Logs Page
Alarm Reference Tables
On the Alarms page in the list that is immediately below the Filter Settings box. This
details the alarm conditions that are currently active on the system.
On the Alarm Logs page in the list that is immediately below the Filter Settings box. This
provides a historical log of when an alarm condition was raised and cleared.
On the Device List page where a traffic light system represents the status of connected
devices.
On the top right hand corner of each page in the web interface where the device status
and system status is displayed.
VNM Recorder • About Alarms
55
55
Advertisement
Table of Contents
