Table of Contents
Advertisement
7.
The firmware installation is complete when the command prompt is displayed in the
terminal window. Manually close the terminal window.
NOTE: The recording application is a service, which means that no application
window will open after the installation has completed.
8.
To finalize the firmware installation, reboot the VNM Recorder by powering down and
powering up the unit (see
VNM Recorder Power Up Procedure
9.
When the VNM Recorder has powered back on, it is necessary to set the folder location
where the recordings are stored (see
on page 34 of the
Navigate Page
VNM Recorder Power Down Procedure
on page 13).
Update Path
on page 33 and
section).
VNM Recorder • Firmware Updates
on page 15 and
Make Directory
67
Advertisement
Table of Contents
