Table of Contents
Advertisement
Configuring the VNM Recorder
NOTE: Initial configuration of the VNM Recorder requires a mouse, keyboard, and
Default Network Settings
The VNM Recorder is pre-configured with the following network settings.
IP Address:
Subnet Mask:
Controller IP Address:
NOTE: Using these settings, the VN-Matrix encoder/decoder unit(s) must use
Configuring the Network and IP Address Settings
Use the following procedure to change the network settings on the VNM Recorder.
Stage 1 — Configure the network settings
1.
2.
3.
monitor. When configuration is complete, it is not necessary to keep these devices
attached to the recorder. The recorder can be completely controlled using the web-
based user interface.
IP addresses within the range 192.168.254.1 through 192.168.254.253 and use the
same subnet mask. The default network settings can also be changed to match an
existing network setup. This is explained in the following sections.
If the recorder is not turned on already, power up the unit and wait for the login screen
to appear on the monitor (approximately two minutes and fifteen seconds).
Enter in the administrator username and password at the login screen (see
Login Information
on page 14 for username and password information).
From the menu bar on the desktop, select
The Network Configuration window appears (see figure 11).
Figure 11.
Network Configuration Window
VNM Recorder • Recorder Configuration and Hardware Setup
192.168.254.254
255.255.255.0
192.168.254.254
System > Administration > Network
.
17
Advertisement
Table of Contents
