Table of Contents
Advertisement
4.
Select the
(upper Ethernet connector; primary network) device line to highlight it. If
eth0
there is a network cable present and it is connected to a switch, the status should read
Active.
5.
Click
. The status of the
Deactivate
6.
Double-click on the
eth0
Figure 12.
Ethernet Device Window
7.
Change the
and
Address
NOTE: The
Default gateway address
different subnets.
8.
Navigate back to the Network Configuration window (see
device and then click
eth0
VNM Recorder • Recorder Configuration and Hardware Setup
device should now read Inactive.
eth0
device. The Ethernet Device window appears (see figure 12).
fields as required and then click
Subnet mask
field is only required if devices are on
.
Activate
.
OK
figure
11). Select the
18
Advertisement
Table of Contents
