Table of Contents
Advertisement
7.
Near the bottom of this file are two values named
an IP address listed under each (see figure 16). Edit these values as follows.
If the VNM Recorder is the controller device, edit both values to match the
•
IP address (eth0) of the recorder.
If the VNM Recorder is not the controller device, change the
•
to match the IP address of the controller device. Change the
match the IP address (eth0) of the recorder.
Figure 16.
Config.xml Text Window
NOTE: Be careful not to change any other values or remove any of the special
formatting characters in this file.
8.
Click on the save icon
Save (current buffer)
9.
Close the text editor window and all other folder windows.
VNM Recorder • Recorder Configuration and Hardware Setup
st_controlIp
Edit this value to match
the IP address of the
controller device.
Edit this value to match
the IP address (eth0) of the
VNM Recorder.
or click on the
menu and select the
File
option.
and
with
st_localIp0
value
st_controlIp
value to
st_localIp0
21
Advertisement
Table of Contents
