Extron electronics VN-Matrix User Manual page 17

Streaming av products
Hide thumbs Also See for VN-Matrix:
Table of Contents

Advertisement

Power input (IEC connector) — Plug a standard IEC power cord into this connector
A
to connect the recorder to a 100 to 240 VAC, 50 Hz or 60 Hz power source.
Alarm Reset button and LED — When the recorder overheats or when a hard drive
B
fails, an audible alarm is activated and the LED turns on to indicate that there is a
problem with the device. Press this button to turn the alarm off.
PS/2 mouse connector (optional) — Connect a PS/2 mouse to this port.
C
PS/2 keyboard connector (optional) — Connect a PS/2 keyboard to this port.
D
USB (Universal Serial Bus) connectors — Insert any compatible USB device into
E
these ports.
Parallel/Printer connector (not used)
F
COM1 serial connector (not required) — Connect a compatible device to this 9-pin
G
serial port.
COM2 serial connector (not required) — Connect a compatible device to this 9-pin
H
serial port.
Ethernet connector (eth0) — Connect a RJ-45 cable to this port. This port connects
I
to a primary network and is the default network port that should be used to connect to
a VN-Matrix network.
Ethernet connector (eth1) — Connect a RJ-45 cable to this port. This port connects
J
to a secondary network.
Center/Subwoofer connector (not required; orange) — Connect a compatible
K
center speaker or subwoofer to this port.
Line in connector (not required; blue) — Connect a compatible line in device to
L
this 3.5 mm port. Use this port to play external audio through the sound card of the
recorder.
Rear speaker connector (not required; black) — Connect a compatible rear
M
speaker to this 3.5 mm port.
Front speaker connector (not required; lime) — Connect a compatible front
N
speaker to this 3.5 mm port.
Side speaker connector (not required; gray) — Connect a compatible side speaker
O
to this 3.5 mm port.
Microphone connector (not required; pink) — Connect a compatible microphone to
P
this port.
VGA connector — Connect a compatible VGA monitor to this port.
Q
7‑pin connector (not active/used)
R
DVI connector — Connect a compatible DVI monitor to this port.
S
VNM Recorder • Panels and Cabling
11

Advertisement

Table of Contents
loading

Table of Contents