Introduction; About This Guide; About The Axi 22 At And Axi 44 At - Extron electronics AXI 22 AT User Manual

Introduction

This section provides an overview of this guide and the features of the Extron AXI 22 AT and
AXI 44 AT audio expansion interfaces. This section covers the following topics:
•
•
•
•

About this Guide

This guide contains installation, configuration, and operation information for the Extron
Electronics AXI 22 AT and AXI 44 AT audio expansion interfaces. In this guide, the terms
"AXI devices," "device," and "AXI" are all used to refer to the AXI 22 AT and AXI 44 AT
interchangeably.

About the AXI 22 AT and AXI 44 AT

The AXI 22 AT and AXI 44 AT audio expansion interfaces are analog-to-Dante/Dante-to-
analog converters in 1U high, quarter rack width enclosures. The AXI 22 AT is a two input,
two output interface and the AXI 44 AT is a four input, four output interface. The inputs
for both devices include preamps with 48 V phantom power and accept 3.5 mm captive
screw connectors. The Dante port on the rear panel of each device provides 2x2 and 4x4
Dante interfacing respectively. Gain and phantom power settings are software controlled
and can be made from the front panel, DSP Configurator Software, or SIS commands
via DataViewer. The AXI will appear on the Dante network and use the Dante Controller
software for routing, device naming, channel naming, transmission latency, sample rate,
and IP communication settings. The AXI 22 AT and AXI 44 AT are pure break-in/break-out
devices that contain no DSP processing.
About this Guide
About the AXI 22 AT and AXI 44 AT
Features
Applications Diagrams
AXI 22 AT and AXI 44 AT • Introduction 1