Table of Contents
Advertisement
Frame Translation Procedure
Use the Frame Translation procedure as follows:
1.
2.
3.
Create an output directory.
To create a new directory on the VN-Matrix Recorder:
a.
Return to the WinSCP window.
b.
Use the mouse to select the window showing the VN Matrix Recorder folders.
c.
Navigate to the required location. Use the <F7> key to launch the
dialog.
d.
Enter the name of the folder and click
Navigate to the directory holding the Frame Translator utility.
The gcode frame translator utility may be found in the same directory as the VN-Matrix
recorder application at the following location:
/home/matrix_rec/VNRecorder_verx.y.z
where
denotes the version number of the VN-Matrix application files. This
verx.y.z
name may vary slightly depending on which version is installed.
In the Command line window, navigate to the directory containing the Frame Translator
utility, using the following commands:
— change directory
cd
— go one directory back up the file hierarchy
cd ..
– list the directories and file at the current location
ls
— show the working directory (your current location).
pwd
Using username "matrix_rec".
matrix_rec@10.100.245.87's password:
Last login: Wed Feb 12 09:26:11 2014 from 10.100.247.143
[matrix_rec@localhost ~]$ ls
Recording_Files VNRecorder_ver9.2.2
[matrix_rec@localhost ~]$ cd VNRecorder_ver9.2.2/
[matrix_rec@localhost VNRecorder_ver9.2.2]$
Figure 53.
Navigating to the Frame Translator Utility Directory
Configure the gcode command line in the terminal window.
Once you are in the correct directory, the command
although, on its own, it won't do anything until it is told which file to work with. Decide
which command line flags are needed and type the command line in the terminal
window. For example:
./gcode ‑t ‑o /home/matrix_rec/Recording_Files/Video_Audio_
Data/TGA ‑i /home/matrix_rec/Recording_Files/Video_Audio_Data/
Chan1_1021526.0.0_r0_s0.rec ‑s 09:44:18.00 ‑f 09:44:20.00
NOTE: To run the utility, gcode must be preceded by the
VNM Recorder • gcode Frame Translator Utility Instructions
in the dialog box.
OK
runs the application
./gcode
characters.
./
Create folder
81
Advertisement
Table of Contents
