Recorder Device Page
This page is accessed by selecting the VNM Recorder device on the
page 26).
Figure 20.
The Recorder Device page shows the basic status for a VNM Recorder device. The device
information is presented in four panels.
NOTE: This guide references the Device page for the VNM Recorder only. See the other
device user guides or click on the
options.
Device Summary panel — This panel indicates the connection status of the device
1
and the status of the management link between the device and the system controller.
Name — The device name can be modified by typing in a new name into this field
•
and clicking
underscore character. Spaces should be avoided.
Serial Number — The field displays the serial number of the device.
•
Device Status — This field indicates the management state of the device. Normally
•
it should show
controller it will show
IP address:port(cport) — This field displays the IP address of the current device,
•
the UDP port the device is using to communicate with the controller, and the
controller UDP port it is contacting.
Link Status — When a device is active, this field displays the quality of the
•
management link between the device and the system controller. A link status of
Good
a small amount of packet loss. A link status of
whether the link to the device has sufficient bandwidth to carry the data and
management traffic.
1
1
3
3
Recorder Device Page
Help
. The name should be comprised of letters, numbers and the
Update
, but if the device is missing or it cannot be contacted via the
Active
No Device
indicates little or no management packet loss. A link status of
VNM Recorder • About the Web-based User Interface
2
2
4
4
tab for information on device specific control
.
indicates a bad link; investigate
Poor
Device List
(see
indicates
Fair
28