Table of Contents
Advertisement
5.
6.
Prompt
•
User name to run
application:
•
Serial number:
•
Licensed Recorder
channels:
•
•
Recorder GUI enabled
(yes/no):
•
•
License checksum:
•
•
Controller IP
address:
•
Controller port
number:
•
•
Local IP address:
•
Controller options:
•
•
Controller checksum:
•
•
Control port:
•
Run the installation program by typing in the following command and pressing the
<Enter> key.
./vnrecorder_install
A series of prompts will start to request configuration information. Use the
config.xml and the admin.xml files (see
Information
on page 64) while using the Firmware Installation Table below to fill in
the requested configuration information.
NOTES:
•
The
Controller options
options key and a checksum which is provided by Extron.
•
If keys have been previously provided by Extron, they can be found within the
file. See
admin.xml
the Firmware Installation Table below.
Firmware Installation Table
Value to Enter
matrix_rec
Serial number of the VNM Recorder
Check the R value (for example,
R5, P5, mR, mP, mV determines that 5 is the
necessary value).
5 is the default value.
Check the mV value (for example,
R5, P5, mR, mP, mV).
If mV is present, answer
Yes
Checksum of the VNM Recorder
Copy and paste the value
The IP address of the device acting as the system
controller
The controller port number
The default value is
5432
The IP address of the VNM Recorder
This is the options key provided by Extron for use in
VNM Recorders acting as the system controller.
If no data is provided or available, leave blank or
contact the Extron S3 Sales and Technical Support
Hotline and ask for a structure key.
This is the checksum provided by Extron for use in
VNM Recorders acting as the system controller.
If no data is provided or available, leave blank or
contact the Extron S3 Sales and Technical Support
Hotline and ask for a license key.
The controller port number
The default value is
5432
Gathering Firmware Installation
and
Controller checksum
and
Controller options:
. Otherwise, answer
.
No
VNM Recorder • Firmware Updates
prompts require an
Controller checksum:
Xml File
Value
Reference
Reference
none
none
config.xml
serial
config.xml
structure
config.xml
structure
config.xml
checksum
config.xml
st_controlIP
config.xml
st_controlPort
config.xml
st_localIP0
admin.xml
options
admin.xml
checksum
config.xml
st_controlPort
in
66
Advertisement
Table of Contents
