GRAPHTEC SignJet JS310-25ES Service Manual page 45

Pouring 150 to 200 cc of cleaning solution into each ink tank
(7) Pour 150 to 200 cc of cleaning solution into each of the four ink tanks (C, M, Y, K).
• 150 to 200 cc guideline amount: The level where the filter in the ink tank is covered.
Feeding the cleaning solution to the sub tanks
(8) From the main menu, select [Ink Status] and then press the ENTER key. The "No ink" alarm sounds and
then stops, and the ink pump operates to feed the cleaning solution to the sub tanks.
If the "No ink" alarm sounds once again, from the main menu, select [Ink Status] and then press the ENTER
key once more. The alarm will stop sounding when the four sub tanks (C, M, Y, K) are filled with cleaning
solution. At this time there will be no operating noise from the ink pump.
(9) Visually check that the sub tanks are sufficiently filled with cleaning solution.
The tanks should be filled up to approximately the level indicated by the white line.
(10) Turn off the printer power supply.
JS310-UM-251-9370
6. Initial Ink Induction Procedure
38