Topcon Pocket-3D Reference Manual page 275

Measure Stake 1
The Measure stake 1 menu is available during side slope or cross
section slope stakeouts only. To activate the Measure Stake 1 menu
(Figure 4-73), first stake out a side slope. See "Side Slopes" on
page 4-41, then tap SurveyStake-outMeasure stake 1.
The Measuring dialog box displays, followed by the results screen
(Figure 4-74). The corresponding Image tab illustrates the
measurements described on the 1.Stake tab.
The 1.Stake tab displays the results of the first point (Measure Stake
1) staked out on the side slope.
• Station – displays the station of the first stake.
• 1. Offset – displays the horizontal distance from the centerline
point to the first stake.
• 2. Elev – displays the elevation at the top of the first stake.
– Delta North: shows north information during a measurement/
stake-out.
– Delta East: shows east information during a measurement/
stake-out.
• Cut/(Fill) – displays the cut value from the top of the stake to the
slope intersecting point. This will always be a cut value if done
correctly.
P/N 7010-0628
Figure 4-73. Measure Stake 1 on the Slope
Stake-out
4-49