Table of Contents
Advertisement
dialog box displays the TIN surface created from the
The preview
selected points and/or lines (Figure 3-40). Press the +/- buttons to
zoom in or out on the image, or press down on the screen and drag the
image around. Press Next to continue.
The TIN surface parameters
ters. Press Finish (Figure 3-40) to display the Surface(s) dialog box
(Figure 3-41 on page 3-28).
• Name for TIN surface – enter the name of the TIN surface.
• Set as current surface – enable to set the surface as the current
surface.
• Ok – press to display the new TIN surface confirmation screen
(Figure 3-41 on page 3-28).
P/N 7010-0628
Figure 3-40. TIN Surface Preview
dialog box sets the following parame-
Surface
3-27
Advertisement
Table of Contents
