Table of Contents
Advertisement
Survey Menu
On the Topo-shot tab,
measurements, then press Ok (Figure 4-22 on page 4-15).
• Prompt for pt. details – enable to prompt for point details every
time a topo-shot is measured.
– Before: enable this option to prompt for point details before
the topo-shot is measured.
– After: enable this option to prompt for point details after the
topo-shot is measured.
• Minimum requirements – the following options define the
minimum requirements for each topo-shot measured.
– Duration (secs): enter the minimum time in secon45ds
desired for each topo-shot.
– H. Precision: enter the minimum GPS+ horizontal precision
desired for each topo-shot.
– V. Precision: enter the minimum GPS+ vertical precision
desired for each topo-shot.
• Press ENTER to measure – enable to use the Enter key on the
controller's casing (below the display screen) to start the
measurement on each topo-shot.
• Require RTK Initialized – enable to allow measurements in a
float/autonomous solution.
• Require mmGPS Signal – allows for only mmGPS+ initialized
measurements. If the solution is initialized only (rather than
mmGPS initialized), the shot will not be accepted. This option
allows measurements in a float/autonomous solution.
4-14
select the desired options for topo-shot
Pocket-3D Reference Guide
Advertisement
Table of Contents
