Topcon Pocket-3D Reference Manual page 139

To configure a new Road surface file, press New on the Surface(s)
dialog box (see "Surfaces Dialog Box" on page 3-26), select Road
(CL, profile, templates) on the Surface type dialog box, and press Ok
(Figure 3-43).
Figure 3-43. Surface Type Dialog Box – Road Surface File
The point of beginning
the following parameters. After setting point of beginning parameters,
press Next to continue.
• Alignment name – enter the name of the Alignment.
• Point of beginning – enter the beginning point.
– North: enter the northing of the beginning point.
– East: enter the easting of the beginning point.
– Observe: press to measure the northing and easting of the
beginning point instead of manually entering in the values.
If the project is not localized when creating a new road
surface, the Observe button will be disabled. Localize the
project to measure the point.
• Start station – enter the value for the starting station of the
alignment.
• Station interval – enter the value of the station interval of the
alignment.
P/N 7010-0628
dialog box (Figure 3-44 on page 3-30) sets
Surface
3-29