Figure 3-34. Support for non-Topcon Base Station
NOTE
The Projection tab
displays a list of pre-defined projections to use for control. Select the
projection for the area in which the jobsite is located.
The Display tab
control points, control point names, and control point descriptions
(Figure 3-36 on page 3-24).
1. To use this option, click DataControlOptions.
2. On the control options dialog box (Figure 3-36), press the
Display tab and do the following and press Ok:
P/N 7010-0628
To achieve accuracy when using the
NAD83_NO_Trans, the correct *.gff format geoid
file must be used.
on the control options dialog box (Figure 3-35)
Figure 3-35. Control Options – Projection
on the control options dialog box displays or hides
Control
3-23