Stop Tape Dimension; Options - Topcon Pocket-3D Reference Manual

• Use ENT to tape dim. – enable the ENTER key (on the
controller's casing below the display screen) to start the
measurement on each taped dimension.
• End polyline – enable to end the polyline.

Stop Tape Dimension

To stop the tape dimension, tap SurveyMeasure ptsStop tape
dimension.

Options

To view or change options for topo-shot or control point
measurements, tap SurveyMeasure ptsOptions (Figure 4-21).
P/N 7010-0628
Figure 4-20. Advanced Tab
Figure 4-21. SurveyMeasure ptsOptions
Measure Points
4-13