Control; Control Points - Topcon Pocket-3D Reference Manual

Control

Control
Used in both 3D GPS+, Total Station, and Robotic applications, the
Control menu creates, edits, and deletes Control Point files. Control
Point files can also be copied between the Pocket-3D controller and
the Control Box using a Flash Card.
Control Point files store ground coordinates and WGS84 values for
each point. These values are required to position the Design Surface
in the proper location. When beginning a job, the project's survey
team locates and measures jobsite control points, called localization.
When beginning a job, obtain a list of all control points in and around
the jobsite.
Before beginning any 3D project, the operator must obtain or create a
new Control Point file. Once stored in the internal memory, select the
correct file before starting localization.

Control Points

To add, edit, delete, or import a control point into the selected Control
Point file, tap DataControlControl points (Figure 3-21).
Figure 3-21. DataControlControl Points
The control points dialog box displays all points within the selected
file (Figure 3-22 on page 3-14).
P/N 7010-0628
3-13