Table of Contents
Advertisement
What's New with Pocket-3D
Base station manufacturer – On the Advanced tab of
the "GPS info" screen, you can now select which GPS reference
station manufacturer to use. This helps with correct RTK
operation where GLONASS is used at the Base and Rover when
the base is not a Topcon base. See "Apply GPS Receiver
Settings" on page 1-20 for more information.
NTRIP virtual ports – It is no longer necessary to manually
specify a "virtual port" for NTRIP corrections because it is
handled automatically handled by the software.
The following list briefly describes the features and functions for
version 9.2 of Pocket-3D, which was an incremental release version
of the Pocket-3D 9.x series for Windows Mobile, Windows CE, and
Windows XP/Vista/7 platforms.
Platforms – In addition to the FC-120, FC-200, and the GRS-
1 controller platforms and Windows platforms, Pocket-3D now
runs on the FC-25 and FC-2500 controllers.
Site-Link 3D – Pocket-3D now supports Site-Link
connectivity, allowing users to transfer files, project data, and
messages to other 3DMC, 3D-Office, and Pocket-3D users on the
jobsite.
• NOTE: This is an Optional feature controlled by OAF. You
must be connected to a Site-Link service (provided directly
by Topcon or by a Site-Link server hosted on the job).
DGPS – You can now select a "GPS (Augmented)" sensor type
for the equipment configuration, which allows you to run without
RTK corrections (or without RTK options in the receiver). See
"Sample Configuration 4: Prism and Total Station" on page 2-32
for details.
RC-4 – Pocket-3D 9.2 supports the new RC-4 modem for
communicating with robotic total stations. See "Sample
Configuration 4: Prism and Total Station" on page 2-32 for
details.
x
Pocket-3D Reference Guide
Advertisement
Table of Contents
