Table of Contents
Advertisement
Figure 4-47. Alignment Stationing Parameters
On the Elevation parameters tab (Figure 4-48 on page 4-32):
• Select one of the following elevation parameters for the
alignment:
– Surface: the surface is whatever you have selected under Data
Surface, i.e., a tin surface, road surface, or plane surface. If
nothing was chosen here, Pocket-3D will not offer "Surface"
as a selection in the drop-down list.
– Extend grade at...: extends the position being used for cut and
fill values, which are defined by the user.
– Add user defined Grade...: extend centerline elevation at a
user-defined slope.
– Centerline: uses the defined centerline elevations of the
alignment to report cut and fill values.
• Add vertical offset – enter a vertical offset in the V Offset field.
P/N 7010-0628
Stake-out
4-31
Advertisement
Table of Contents
